|
Caution
| Assembly | Accessories
Use
CAUTION:
The standard plastic tabs are made of PETG plastic. Avoid use of the Standard
PAPER-TRACKER in applications with exposure to direct sunlight or areas of high heat.
Available upon request: Special heat-resistant plastic tabs made from PC plastic may be used for applications with exposure to direct sunlight or areas of high
heat.
ASSEMBLY:
Bar version Nest the plastic pieces so the four tabs are on one side. Hold firmly together and slide on the Binding Bar.
Desk/TableTop version Nest the plastic pieces so the four tabs are on one side. Hold firmly together and insert one end into the DeskTop Base channel. Push down into place.
Novelty version Nest the plastic pieces so the four tabs are on one side. Hold firmly together and insert one end into the pre-cut channel(s) on the object. Push down into place. Plastic tabs can be inserted facing either direction. Try both to obtain the best document display and stability for your needs. 
ACCESSORIES USE:
Adhesive Pads for Direct Mounting Use the enclosed double stick adhesive pads to attach PAPER-TRACKER to almost any surface; do not attach to flexible plastics, wallpaper, leather, or vinyl surfaces. To remove adhesive- pad-attached PAPER-TRACKER, use a knife to cut the pad between the object and the binding bar, and then remove the
 adhesive pad residue with your thumbnail.
Magnet Strip Accessory Stick the magnet strip adhesive surface to either the back of the plastic tab set (about 1” from the top) or to the back of the Binding Bar.
Double Clip Accessory Attach small clip to Binding Bar. Attach large clip to object.
Clip-Magnet Accessory Attach small clip to Binding Bar. Attach magnet to object.
|
